jetsurgeon
Veteran
Location: Raleigh, NC
| Ok what’s the secret here, or am I just way to tired and brain fried? Please help Futaba Guru’s!
Problem: Throttle ATV’s and Throttle Cut.
Radio: Futaba 9ZHP
Engine: YS .80 ST3
Servo: Futaba 9202
Throttle Curve: Linear
1. Throttle ATV’s set to 96% A (Low Stick) – 96% B (High Stick): Engine index marks line up for full throttle, ½ throttle, and close. Everything is at 90 degrees.
2. Now how do I set up “Throttle Cut”, not the switch….
Is the secret to decrease the Throttle ATV “A Side (Low Stick)” to something like 86%, (so throttle is actually open from throttle close) and then set the “Throttle Cut” rate to a value that closes the throttle barrel?
If this is the answer, my Throttle ATV’s would be 86% A (Low Stick) – 96% B (High Stick), and then with Throttle Cut Enabled, the throttle would actually close, (like it was set up at 96% A in step #1. Is this correct, or is there a better way, so that I can keep 96% A – 96% B, and then have the throttle cut to retard the throttle barrel to close?
I’m so confused, I should have been in bed 7.5 hours ago…..argh!!!
Thanks!
Jeff Galford |
