rrTV-PHOTO   New HD TV
HOME   rrTV-PHOTO   GALLERIES   MY GALLERY   HELP-FAQ
myHOME PM pmRR MEMBERS 562 ONLINE 42 EVENTS SEARCH REGISTER  START HERE
 
1 page421 viewsPOST REPLY
GrandRC . CanoMod . Futaba-RC

.
.
Radio - Servo - Gyro - Gov - Batt > Which servo for JR G410T Gyro ?
 
 
Jack_R30
Senior Heliman
Location: Puchong, Malaysia

I plan to upgrade my tail servo (currently is Samwa 102), which is the minimum servo i need ?

TQ


Jack
04-11-2002 Over year old.
 
 
Jack_R30
Senior Heliman
Location: Puchong, Malaysia

Does that means I connot connect a digital servo with my G410T gyro ??

My current Sanwa standard servo work well in Normal mode, but when I switched to Tail Lock mode, the servo move to one direction.


Jack
04-12-2002 Over year old.
 
 
Dr.Ben
Elite Veteran
Location: Richmond, VA, USA

Your servo is probably moving in HH mode because you either have some subtrim or regular trim in the transmitter. You need to zero everything out and then carefully adjust the trim until the servo stays stationary or nearly so while in HH mode. If you hover the model in rate, make sure you make all necessary trim adjustments mechanically; leave the trim lever alone.

Ben Minor
04-12-2002 Over year old.
 
 
Jan Thore
Senior Heliman
Location: Bergen, Norway

Try to use JR 810G gyro servo wich is low cost and good prefomance.

You can ofcourse also us JR 8700G Both of them is analoge servos.
04-13-2002 Over year old.
HOMEPAGE  
 
 
flawless1
Heliman
Location: Fort Wayne IN.

Servo

I believe the JR 8700G servo is for pcm only. It was suggested to me to use the JR 4735 ultra speed servo to work with the JR410t. Also it says in the direction of the 410t gyro that it is normal in HH mode for the servo to slowly move in one direction.

hope this helps
Doug
04-16-2002 Over year old.
 
 
1 page421 viewsPOST REPLY
A Main Hobbies . Boca Bearings . Modefo's RC Helicopters

.
.
Radio - Servo - Gyro - Gov - Batt > Which servo for JR G410T Gyro ?
  UPDATE SCREEN   PRINT TOPIC Advertisers 

Subscribe to This Topic

Friday, September 5 - 5:31 am - Copyright © 2000 - 2008 runryder.com | email | link to rr | runryder needs cookie