DenisS
Key Veteran
Location: Essex, UK
| I have the instructions for these somewhere, I will e-mail you a copy if I find them.. I still have a Quest gyro that I had serviced a few years ago and haven't used since. They updated the PC board. To be honest you'd be better off with a cheap piezo. For your information if you stand the gyro on the small end with the wires at the bottom facing you then the centre wire, female, goes into the rudder channel on the rx, the left hand wire, male, has the rudder servo plugged into it and that leaves the right hand female wire that is the gain channel. I think the earlier ones didn't have a reverse switch but my one has, otherwise you have to mount the gyro upside down to reverse it. Set the gain screw on max and use channel 5, or whichever you are using as the gain channel, ATv's to set two gains.
DenisS |
