I am trying to connect the gyro to the PC (Win XP) but get an error message: "CSM USB interface not found. Connect interface and re-try"
I have downloaded the USB drivers and installed them via the .DLL files but there still seems to be a problem.
Also - I plugged a 5.5 V powerpack into one of the gyros and the red pilot came on. Did the same on the other one and it is completely dead (no light)....
Suggestions appreciated to fix these issues - TKS.
Yes I did that but no luck. I am using a generic USB to RC (with a 3 pin servo plug attached) - that came with the AP 2000i. Would this perhaps making a difference?
08-12-2008 02:18 PM
Bad Karma Veteran Location: UK
Could be, I have a PIC programming board that when its plugged in my realflight G2 controller refuses to work.
USB devices can sometimes interfer with each other, you can only try it.
08-12-2008 05:51 PM
3D Heli Ireland Veteran Location: Ireland
You will need to use the proper CSM USB interface, it's a dongle thing.
Miniature Aircraft USA Motors & Rotors CSM FlightPower SAB Cool Power SwitchGlo
