z11355
rrMaster
Location: 10000 is enough time wasted.
| On the Revo. antennas, I've used drilled out Dubro control horns to mount it to various parts of the machines.
On the Rap, I used a Deans and Goop'd it to the little 1" square in front
of the pitch arm and bent it foward and down. Or you can drill a small
hole in the landing gear or somewhere and mount the horn there.
I had one right in the middle top by the glow plug and the Revo
antenna was was sticking out like a pitot tube in a small hole in
the canopy. Ultimately, I removed the Revo and used the Deans
instead because the Revo was not workig well in that location.
Generally though, I prefer the Revo and try to use it vs. the Deans.
It's one of those 'experiment' things.
On the Freya, I used a Revo. antenna and enlarged the holes in
the landing gear slightly and slide the antenna through, then used
a piece of fuel tubing over the end and a SHCS through the other skid
to fix the tip. When I changed to Tuff Struts, I simply used two small
plastic wire ties in an X pattern on the front skid and put the antenna
tube through the X. This doesn't support the tip however. I'd
recommend getting some really small spiral wrap or so and protecting
the wire and also clean and tape over the connector pin. |
