S76 Mech
Elite Veteran
Location: Hatboro, Pa.
| Set your 610 to (4S), your charge amps should be set 2.00 amps for a 2070mah pack to charge at 1C.
For example: I charge my 6S 2600mah 25C packs at: (6S)/(2.60 amps)
Press amd hold the 'red' button to start the charge process. Once the charge is started, the 610C will check to see if your balancer is connected, then it will perform and 'initial' charge. Right after that, it starts to ramp-up the charge amperage to the pre-selected amperage.
Once your charging the display will show charge time, mah put back into your pack, charge amperage, and pack voltage.
While its charging, you can push the 'green' mode/select button and it will show the voltage of each cell and also the balancing of each cell shown by little circles.
That should get you going! |
