RunRyder - Jazz 55-10-32

rrTV-PHOTO

New HD TV

HOME rrTV-PHOTO GALLERIES MY GALLERY HELP-FAQ

myHOME PM pmRR MEMBERS 296 ONLINE 28 EVENTS SEARCH REGISTER START HERE

1 page

223 views

POST REPLY

Modefo's RC Helicopters	.	XHELI.COM	.	Autography FlightPower
	.		.

e-Electric Motors & Controllers > Jazz 55-10-32

Long Nguyen K.
Senior Heliman
Location: SoCal, USA

I just bought a Jazz 55 for my Protos (500 sized heli) and have a really strange problem. That is sometimes the motor shuts down for about 0.1 sec and then runs again like normal. It seems to happen at the end of the flight.

I'm running spektrum system so there should be no electronic glitch. My RX is 1.6 version and if there was a lookout due to receiver reset it should have been blinking but it does not blink after the problem happens so there should be no receiver reset.

My motor is rated at 800KV and some testing showed that the motor peaked at 55A on 6s. That should be fine for the jazz 55.

Any ideas?

Long Nguyen
My SHAVER is cutting rice!

06-04-2008 06:56 AM

HOMEPAGE

MrMel
Elite Veteran
Location: Lidingo, Sweden

Read up on RCgroups regards to static discharge, I suspect that is the cause...

A Jazz when it "cuts out" meaning overcurrent, over temp etc, it lower the RPM to about half, it dont "cut out completly"

Team Autopartner - Team pilot

06-04-2008 01:41 PM

"Cam"
Veteran
Location: Japan

I've had that problem. I solved it by taking a wire from the boom to the -ve on the ESC (and battery once plugged in).

06-04-2008 03:59 PM

Long Nguyen K.
Senior Heliman
Location: SoCal, USA

I grounded the boom to the motor plate already. And as the matter of fact, I didn't have any glitch in aileron, elevator and rudder before or after I did the grounding. However the "glitch" in throttle has been there since the beginning.

I'm running 60% throttle curve governor mode so could that be the reason why the ESC has been over-amped?

Long Nguyen
My SHAVER is cutting rice!

06-04-2008 04:31 PM

HOMEPAGE

MrMel
Elite Veteran
Location: Lidingo, Sweden

Quote
A Jazz when it "cuts out" meaning overcurrent, over temp etc, it lower the RPM to about half, it dont "cut out completly"

and it gives notification via the led on the jazz, motormount isnt always enough for static removal, sometimes it has to be the negative lead directly.

Team Autopartner - Team pilot

06-04-2008 04:43 PM

Long Nguyen K.
Senior Heliman
Location: SoCal, USA

Thanks I will look out for the led signal.

Long Nguyen
My SHAVER is cutting rice!

06-04-2008 04:55 PM

HOMEPAGE

1 page

223 views

POST REPLY

Advantage Hobby	.	Revolution Models	.	CarbonXtreme
	.		.

e-Electric Motors & Controllers > Jazz 55-10-32

UPDATE SCREEN PRINT TOPIC

Advertisers

Subscribe to This Topic