3d-wanna-b
Heliman
Location: Newport, Ar. U.S.A
| OK, Anyone received one of the updated steel feathering shafts yet? I've seen some that had the ball in the center and some that didn't. Which is the newer version?? Also if someone has an extra feathering shaft laying around could you get me a measurement of it end to end and a measurement of the width of the head outside edge to outside edge where the dampers go in?? I worked on the head all night without any avail except screwing up a set of dampers I've checked all the grips and bearing and all the bearings are seated. I've measured the grips and all are identical. All I can think of is the head block is bad or the feathering shaft is to short. Any way if anyone can get me some measurement's I'd be very grateful
<<HeliFreak>> |
