Radio - Futaba FASST > Any Micro recievers that work with the FASST system that use normal plugs?
Ken B Elite Veteran Location: Phoenix, AZ
In my hurry to buy a New FASST module and reciever for my T-rex I discovered that I ordered a reciever that takes micro plugs. Well, I am not able to change the connecters on the GY401 Gyro to Micro.
Now I want to get a micro 6ch 2.4 reciever that will work with FASST and normal servo plugs. Anyone know of any???
(retorical question) Why did Futaba not make a micro 2.4 reciever that took normal plugs??? UGH!!!
Sparkhead Key Veteran Location: Melbourne Australia
Is the 617 to big for you? Not a bad size I thought, I have some 606's nut they are the same size as the 617. Make sure you get a 617 and not a 607 because the channel grouping is better on the 617 for CCPM mixing.
Mick.
Robbe & Futaba.
05-07-2008 07:24 AM
AltecLansing Veteran Location: Under the tire of a truck
what futaba fasst receiver uses micro plugs?
Man, I miss the eighties.
05-07-2008 10:16 AM
Ken B Elite Veteran Location: Phoenix, AZ
I was actually hoping that another compatible brand. Guess not. The Reciever I have is the R616FFM. I looked at the 617 and might exchange this for that, the 617 is 3grams heavier but I might not have a choice in this matter.
617 is much smaller and lighter than the R146iP which was the most commonly used Futaba 72Mhz receiver in T-Rex. You should have no problem with 617 in your T-Rex.
Or you can remove the casing and shrink wrap it to save even more weight.
05-08-2008 04:50 PM
I3DM rrProfessor Location: Israel
The R606FS has micro connectors.
Team pilot for RJX, Helidirect, Logictech, ThunderPower, Fromeco www.liorzahavi.com
