RunRyder - Jazz 80 help

rrTV-PHOTO

New HD TV

HOME rrTV-PHOTO GALLERIES MY GALLERY HELP-FAQ

myHOME PM pmRR MEMBERS 626 ONLINE 72 EVENTS SEARCH REGISTER START HERE

1 page

77 views

POST REPLY

Futaba-RC	.	Blink Helicopters	.	Fast Lad Performance
	.		.

e-Electric Motors & Controllers > Jazz 80 help

buffythesaint
New Heliman
Location: Ontario,Canada

I recently purchased a Jazz 80 but don't get a ready tone when I plug in my flight battery,22.2V 5000Mah. All I get is a steady single flash on the LED. The baterry pack was fully charged. I plugged in a 4 cell 2100 lipo and I received the ready tone. I removed the jumper and programmed for heli mode and redid it again for lipo mode, no probs. I bumped the motor on my Trex600 and it worked. I unplugged the 4 cell and put my 6 cell on and I get the steady single flashing LED, no ready tone. Any help would be appreciated.

Buffy.

05-06-2008 03:19 AM

Jag72
Key Veteran
Location: 20 minutes south of Boston Mass...

Endpoint adjustments...

Did you adjust your endpoints with a 0-100 linear curve in normal mode?

if you do not do this the ESC will not know the correct endpoints and will not arm..

Roxxters ROCK!!!

05-06-2008 03:18 PM

buffythesaint
New Heliman
Location: Ontario,Canada

Jazz 80

No luck with the Jazz80. My endpoints are good and the curve is linear. The ESC will arm with a 4 cell lipo but won't arm with a 6 cell lipo. I reset the ESC to factory settings(mode 1) but still no luck. Is it possible that the ESC high voltage limit was set to low at the factory? If that was so I should see nine fast flashes indicating too high voltage. All I get is a single flash which the trouble shooting guide says under voltage. Perhaps its time to return it and ask for a replacement. Thanks for the advice.

Buffy.

05-07-2008 06:20 PM

1 page

77 views

POST REPLY

Center Stick	.	Esprit Model	.	Thunder Power RC
	.		.

e-Electric Motors & Controllers > Jazz 80 help

UPDATE SCREEN PRINT TOPIC

Advertisers

Subscribe to This Topic