rrTV-PHOTO   New HD TV
HOME   rrTV-PHOTO   GALLERIES   MY GALLERY   HELP-FAQ
myHOME PM pmRR MEMBERS 782 ONLINE 73 EVENTS SEARCH REGISTER  START HERE
 
1 page143 viewsPOST REPLY
Fast Lad Performance . Esprit Model . Thunder Power RC

.
.
Radio - Servo - Gyro - Gov - Batt > Can not get into display mode with G-view and ATG
 
 
syl
Heliman
Location: Ireland

I am having an issue where by I can not get into the display mode with the G-view and ATG. I have set it up with out the G-view but would like to go over the settings with the G-view. I have the ATG V2 (blue sticker on box) and with all wires connected I do as per instructions - hold down "p" button for 6 seconds, but no display appears, the G-view continues to show the inital screen. I have also tried holding the "p" button down and powering on Rx (as per ATG V1) but still no display mode.
Is there something I am missing, should the display mode show while the "p" is held after 6 seconds or will it display after I release it after the 6 seconds.
My G-view works great with my Solid G.
Any suggestions !!!
05-05-2008 11:07 PM
HOMEPAGE  
 
 
tadawson
Key Veteran
Location: Lewisville, TX

The instructions also say that it may take longer than 6 seconds . . . how long have you waited? I also found on mine that if the voltage was low, I could never get the G-View to come up, and if anything, it started freaking and dropping characters. You might want to check you battery as well.

- Tim
05-06-2008 02:49 AM
 
 
syl
Heliman
Location: Ireland

Hi Tim, thx for reply, I have waited for up to 10 seconds and still no display, plus the Rx pack is fully charged (Thunder power 3400Mah lipo).
Should the display come up at any stage during setup with lights?
I have a second ATG coming this week so i will be able to check against that, if it works ok, then I think there is somthing wrong with this one. If I open it to check any solder joints for where the G-view connects (mainly yellow wire), will I void the warranty?
05-06-2008 10:53 AM
HOMEPAGE  
 
 
tadawson
Key Veteran
Location: Lewisville, TX

The other thing I recall, and not sure if it was on my Solid-G or the ATG, is that at least one of them would not come up if it didn't see a signal from the TX to allow it to finish initializing . . . .

- Tim
05-06-2008 08:47 PM
 
 
JWatson
Senior Heliman
Location: College Station, Texas

Syl,


Sent you a PM. We will get this sorted out.



Jarrett W.
05-08-2008 07:27 PM
HOMEPAGE  
 
 
1 page143 viewsPOST REPLY
Real Raptors . Mikado Modellhubschrauber . GrandRC

.
.
Radio - Servo - Gyro - Gov - Batt > Can not get into display mode with G-view and ATG
  UPDATE SCREEN   PRINT TOPIC Advertisers 

Subscribe to This Topic

Tuesday, May 13 - 7:02 pm - Copyright © 2000 - 2008 runryder.com | email | link to rr | runryder needs cookie