RunRyder - Assembly question on page A4

rrTV-PHOTO

New HD TV

HOME rrTV-PHOTO GALLERIES MY GALLERY HELP-FAQ

myHOME PM pmRR MEMBERS 644 ONLINE 44 EVENTS SEARCH REGISTER START HERE

1 page

190 views

POST REPLY

GrandRC	.	CanoMod	.	A Main Hobbies
	.		.

Synergy R/C Synergy N9 > Assembly question on page A4

wings19
Senior Heliman
Location: Traverse City, MI

I am reassembling my Synergy after my crash and have a question about the main shaft assembly(page A4).

The M4x8 bolts(part #100-408) that go through the main gear and hub assembly into the main shaft seem a little long. They do not fully go into the assembly, they stop when they hit each other in the middle. Is this correct and should I just tighten them against each other?

I can't remember what I did in the original build...

Nick
If the wings are travelling faster than the fuselage, it's probably a helicopter

04-24-2008 05:36 PM

HOMEPAGE

Rymps
Senior Heliman
Location: Windsor CO

No they should not hit each other. I thought they were 4x6mm bolts. Thanks

04-24-2008 05:52 PM

creightoncarr
Veteran
Location: Missouri City, Texas - USA

Do you have the collar the goes around the sprag assembly in place before bolting it to the main shaft? Without it the bolts would be too long and meet in the middle like you are describing.

04-24-2008 06:18 PM

gator
Senior Heliman
Location: Alexandria, La.

Make sure you have the main gear hub collar on 110-150 (page A3) and the(100-408 M4x8) socket head bolts should go in fully without touching each other. Hope this helps

04-24-2008 08:06 PM

wings19
Senior Heliman
Location: Traverse City, MI

Yeah I think I forgot the collar

Thanks guys I don't know what I was thinking... It is harder when all my parts are in a dish instead of organized bags!

Nick
If the wings are travelling faster than the fuselage, it's probably a helicopter

04-25-2008 03:13 AM

HOMEPAGE

1 page

190 views

POST REPLY

Boca Bearings	.	Modefo's RC Helicopters	.	XHELI.COM
	.		.

Synergy R/C Synergy N9 > Assembly question on page A4

UPDATE SCREEN PRINT TOPIC

Advertisers

Subscribe to This Topic