Hi. Building a SWM evo50. Confused about the cyclic servo wheel setup.The manual says : the servo holes 12,5mm from the center hole - a line through the holes is in the centre of the servo - 90 degrees is marked between X arm pivot to the servo pivot points and the rod ends. I do not think this will be the optimal geometry.The rod ends should have been 90 degrees to the centre of the x arm and the centre of the servo. Am I wrong?? Have read about a 2 degrees offset, -- but not according to my manual. Help please.
04-20-2008 05:46 PM
guhj Heliman Location: norway
My mixer arms have no offset. My manual says no offset on the servo wheels either. The linkages are not parallel. Will an offset on the servo wheels make it all more smooth with less binding??
Look closely in the manual there should be a 2 deg. offset.
Evo50 YS50, MINI LAMA,TREX450XL,ALL Futaba
04-28-2008 03:48 PM
guhj Heliman Location: norway
Thank you Zoomcorvette. Have been reading the manual again and again. I have the "Shuttle Sceadu Evolution SWM" manual No.10956. Unable to see the 2degrees offset.
