Rogan
Senior Heliman
Location: Houston, Scotland - UK
| Just enough for the cyclics, there's a little leeway where to mount the forward grommets, so it's not that bad. I'd say you can lift the canopy as much as 10mm higher if needed. The internal shot was just for checking the position of the cutout. The canopy sits much higher at the front than it appears to in that photo.
Muffler does need a little cutting, I borked something with the alignment. I'll be able to get away with a small notch at the bottom of the indent.
You also need to mount the throttle servo inside the frame to give clearance for the horn and linkage. I'm going to use a low profile servo for this so I can access the glow plug. You can get away with a full sized servo but you might have to pull it to fiddle with your plug.
I saw the idea in here a while ago. I was a bit reticent to take the chance on it, but it seems to be working reasonably well so far.
The above text is not intended to cause offense, unless implicitly stated. |
