Jujiro Senior Heliman Location: Jennings, Louisiana- USA
I recently crashed and have to remake a few of the linkage rods , but I have no idea what length they should be since my manual doesn't have them listed. Can anybody give me the general length the rods are supposed to be ?
03-04-2008 04:45 AM
Eagle2bravo Senior Heliman Location: went to find a broom & dustpan,.... I crashed
I'll go measure um up ..... I'm still at the office I'll get back to ya soon.
03-04-2008 11:49 PM
Cryofix Heliman Location: Easton PA
40 mm for the washout to seesaw, that's all I have
03-28-2008 04:40 PM
realwiz Senior Heliman Location: Medina, Ohio, USA
I sure would like this information as well. I bought my Gaui already partially built, and I think the head is setup wrong. 0 pitch is a lot higher than 7mm as the instructions state.
h8gravity Heliman Location: Florence, Arizona - United States
All my links on the head were wrong. The best thing to do is build the swash links first so that the swash is sitting 7mm from the top of the frame like in the manual and then slowly work your way up the head until everything is correct. Somebody's measurements would help but everybody's mileage is different depending on what sub trims and so forth are set at.
I'll get back to ya soon.
