jschenck
Elite Veteran
Location: La Vista, NE.
| I am FINALLY at the point where I can start building my Predator Gas SE NX. I worked on mounting the fan tonight and thanks to James "AGRAV8"'s build thread I got the fan to less than .002 by lapping in the fan a bit then tapping it a little before snugging it down. I didn't use the bolt's he suggests because of the ESS plates don't allow for them.
Anyhow feeling pretty good about the fan I went to mount the clutch. The instructions call for M4x6 bolts to hold the clutch in place which I found in the bag with the starter shaft hardware. Well these bolts may have fit just fine with the original style fan hub but there is only about one thread worth of bolt sticking through to engage the clutch. Good news is, at least without tightening down the bolts my clutch runout is zero. Hope it stays that way!
Does anyone know what the proper bolts are for the clutch?
...yep... |
-.jpg)
