concept1
Key Veteran
Location: Youngstown, OH
| use the battery that came with the BEC, (small 2 cell) and their is a very small on/off switch along with 4 LED's on the BEC to tell the voltage. this will run the servo's. you won't need the battery that came with the Rx. The 2 11.1v packs run the motor though the esc. you will turn on your transmitter then the BEC, lastly plug in the 2 packs into the esc. always turn on in this order, and turn off the reverse order!!!! don't plug in the 2 11.1 packs till you get your servo's setup, then I would recomend testing with the motor removed from the frame if this is your first electric Heli.
as for the order of the servo's it depends on your radio, in your manual it should say for CCPM which servo goes where. but if not trial and error will get you their. start with moving the elev stick and make sure it moves the center servo, if not move till you get it. for Pitch all 3 servo's move and aileron the front 2 servo's move. also you will need to make sure they all go the right direction, this also could just be trial and error (again start with elv, when you pull back on the stick it should move the back of the swash down) move right the right side of the swash should go down, left go up. |
