npap
Heliman
Location: Toulouse - FRANCE
| Hi,
I give you somes photos:
   
all these parts are made in metal by my father. The part on the main blade grip follow the design of it and are just screw throught the original hole. The part which avoir washout is in metal too, and just screw with 3 little pressure screw and allow pushrods to move for pitch witout any perturbation. The interest to put the ball link on the rotor head at 90° is to avoid pushrods pulling out with lots of pitch
...
For gyro the settings it's in test...
Hope this help
Regards
norbert-FRANCE
Sponsored by CSM |
