DarkHorse1
Senior Heliman
Location: Gloucester UK
| Hi, to be honest I don't see a need for any tail upgrades (cause I'm short of cash and very tight  ) and use stock tail setups for 2 X-3Ds and the MS Ecureuil.
EDIT: sorry you said H2, not X-3D, so yes upgrade the tail 
Recently worked on a friends X-3D with almost the same tail as yours... What I did notice was that I had to slightly enlarge the plastic yoke arm holes (E229) to accommodate the metal blade grips smoothly, bent the yoke very square and added a smudge of Vaseline to the interface between the yoke and grips, plus a little on the tail output shaft to ease the run of the brass slider. Then reduced slop in the servo and 'L' shape linkage. Best results when total freed up without slop.
Yes the brass slider tube does rock a little on the shaft, I even tried careful squashing in the past to reduce slop but the effect is minimal on tail performance. I have a stock X-3D with tones of slop (relatively to the others) and the tail still performs very well and stable in hover and mild acro.
If you still have a wag the check my tips page here and check the link on vibes. |
