PsychoPilot145
Heliman
Location: Houston, TX - USA
| I am a noobie, and just purchased an DX7, and a CSM SL720 gyro. When you explain what I need to do, remember, that I am new to this, and will need a simple explanation using layman's terms.
All indications so far are pointing to my DX7 as the culprit.
I have a Trex 600, which does fly OK in normal rate mode. BUT... I am not able to access the quick setup on my gyro. This is accomplished by toggling the HH switch on the radio during gyro boot. Also, I am unable to turn on HH mode. The gyro functions under the default settings, but I cannot get into setup, or use HH. The gain on my DX7 is set to 72% per channel which should equate to 32 for a gain. The gyro is operated off of the gear channel as recommended.
When I toggle the DX7 gear switch with the monitor page up, nothing happens. Indications are that the DX7 is not sending a signal from this switch.
All of the settings in the gyro are set to default, except the sensing is normal, instead of reversed.
Being a noob and learning how to fly all together, it would be nice to have HH mode.
What am I doing wrong?
I am just about at my wits end.
Many thanks in advance,
Mark |
