Mode3
Heliman
Location: Sydney Australia
| Hey Orion,
Sorry about the delay, have been busy ,will get backc shortly with pics and info, in short- if you look at the left and right side of the main board you will see two connectors ,one which starts off with a yellow trace wire and the other with a red . You simply cut extend and cross these wires over (including the following 2 white wires from each connector) these 3 wires from each side controll the trims for either side the left over 3 white wires from each side controll the your rudder and roll. these are the origianal 3 that should have been crossed over in the first place to do the conversion.
I think you did the conversion the other possible way on yours .
PS just remember this will swap the trim controlls over BUT the DISPLAY will still show the trims Ass about.
Regards Mode3
MODE 3 FOREVER. PS I also found it very convienient to stiffen up the spring on the rudder gimble so as to minimise accidental rudder moves when applying collective.
YO  |
