| |
| cgbole | Veteran - Location: tulsa ok - |
here is a short post on installing this it's super easy.....
"even a caveman could do it"
remove all glow components, tank,shroud,shroud supports ect... remove the clutch assy, and bell assy.
then seperate the upper bearing block from the pinion, if using a different tooth count pinion.if using the 11T pinion just unscrew it from the bell.then screw the pinion into the adaptor. and insert the pinion back into the bearing block.
now bolt the motor onto the mount plate
place the adaptor and pinion assy onto the motor shaft
then insert whole assy. back into the frames
then take the upper carbon plate and slot the holes, to adjust the gear mesh.
i slotted the lower holes...
the pictures show the main gear installed during this but it is easier to do this with out the main gear in the heli...
i flipped the upper plates over so the ingraving is toward the frames. you might have to slot the holes a little more to get the holes to line up when setting the gear mesh. i run the mesh pretty tight (already stripped the teeth off one 100T main gear.
install batteries i placed one pack under the radio tray on the front, and 1 battery where the fuel tank sat.
 |
| 03-28-2007 06:27 PM | | | |
