mystar60
Senior Heliman
Location: Clifton, NJ
| Try this, I just left Horizions site and was able to retrieve the manual .
http://www.horizonhobby.com/product...ab=support#tabs
Kevin
TAIL CENTER HUB ASSEMBLY
Slide the Tail Slide Ring Assembly on the Tail Output Shaft before installation
of the Tail Rotor Hub. When attaching the Tail Rotor Hub, be certain that the
two 3x3mm Set Screws engage into the holes at the end of the Tail Output.
Tail Center Hub
Tail Blade Holder Bearing
(Sealed) (2 pc)
Tail Thrust Bearing
3x3mm Set Screw (2 pc)
Tail Slide Ring Assembly
10x7mm Washer (Large)
Large I.D.
Small I.D.
7x4mm Washer (Small)
Tail Blade Holder Bearing (Open) (2 pc)
3mm Lock Nut
3mm Lock Nut
Caution: Be sure to note correct
placement of Large/Small I.D.
Thrust Washers during assembly
When assembling, check to make sure
the Tail Blade Holder Bearings can rotate
freely, without play. If binding occurs,
loosen the 3mm Lock Nut Slightly.
....2 pc
3x3mm Set Screw
....2 pc
3mm Lock Nut
....2 pc
Tail Blade Holder Bearing (Sealed)
....2 pc
Tail Blade Holder Bearing (Open)
....2 pc
Washer, 10x7mm (Large)
....2 pc
Washer, 7x4mm (Small)
....2 pc
Tail Thrust Bearing
Use Threadlock
TWO SETS REQUIRED |
LOL.
I decided to break out my ERGO 60 and hook it up with some new DNHP upgrades. But before that I need to get it flying stock again. However, I can not find my manual. Does anyone know where I can find an exploded view of the tail rotor output shaft section for the Ergo 60? Or somewhere I can download a manual? Horizons manuals and PDF files havent worked in a long time. All I need to know is the correct way to secure the tailrotor hub to the output shaft.
