do I should I put washers on either side of the tail blades? Not called for in the directions but as hard as I can screw them down they are still so loose they just drop. I know they should center and loose should NOT be an issue but these actually have so much slop they can woble in the grips
Think I might need the tail CNC goodies
02-01-2005 Over year old.
go2heli Heliman Location: Chico
You either have the grips on backwards or the blades. Most likely not the blades since you know wich way they turn. The screw goes through one side then tightens down on the other( one whole is larger then the other)
02-01-2005 Over year old.
bevoduz Veteran Location: Normal, IL
I had this issue too, I believe it's just your grips, I flew as is and it was fine.
