kyoshokamper
Senior Heliman
Location: HOUSTON, TX, U.S.A.
| c60 cf fins & boom supports & pushrod/rear servo mtHere we go guys and Butch R on those specific part numbers for carbon fins/boom/pushrod/and rear servo mount modifications posted earlier by me. Firstly, everything can be viewed and purchased from ronlund.com and I would suggest using these part#s for a search on his site. Secondly, the general rule is that any boom parts for Raptor 60 will fit the Concept 60 Series birds. Here goes:
1. JH2-silver aluminum 1pc boom clamp @ $30, the 2pc purple one will fit too.
2. RCHFR60-carbon fiber fins/direct fit, no drilling! @ $30
3. VAR8_5-vario black plastic rear boom servo mount @ $12.95
4. CAPRSM-alternative rear plastic boom servo mount(I have not used this one) @ $15.00
5. MA0868-2-Miniature Aircraft's rudder pushrod kit with 2 ball ends, 2 guides, 2 teflon shrink wear tubes, 2-2mm all thread pieces pre-cut to length and 1 long long carbon fiber rod! Perfect! @ $15.80
6. MA0868-4- 2pc teflon shrink wear tube @ $1.14 just fyi for closer viewing
7. MA0868-5- 2pc black plastic pushrod guides @ $2.20 just fyi for closer viewing
8. RCHBS-carbon fiber boom supports @ $24.00
9. CAP34114-Boom support bridge @ $8.45, I have used both
10. KSJ535-Boom support bridge @ $8.96, I have used both, both ok
Use only 1 black oem black plastic pushrod wire guide and bolt only 1 of the MA pushrod guides to it and make the cf pushrod to fit perfectly perpendicular to the boom with the rear mount. Don't forget to install the 1-pc boom clamp before the black plastic oem guide. Don't for get to use a bit of thin ca on the teflon shrink tubing just before heating. Wick the ca in between the tubing and the completed cf pushrod. It will be beautiful and a perfect fit for all!
Blade Runner, I'll post my findings on tail boom support anchor point lowering later. |
