rwj
Veteran
Location: Kenosha Wi
| I have the buffer plugged into my ele chan on my rx and the other end is plugged into the ele wire coming out of the CP computer. The ele servo wire is plugged into the ele slot on the CP computer. the ail servo wire is plugged into the ail slot on the CP computer.I have all 4 little switches in the on position. I am not using the on off swich, that wire I have disconnected. I have the gain turned all of the way up. I put the heli on its side, pressed the red button once, it osolated 4 times then I set it upright on level ground and walked away. When it finished doing its calibration I then gave the right stick full right. Every time the the swash plate always ends up in the forward up position and stays there. as if I had my hand in front of the heli. I have the sensor mounted about 8inches back from where the boom goes into the main frame. It is mounted in a cris cross position. I have a Futaba Super 8 with a PCM rx. Has anyone else had this problem? When I push the red button I am to the back and off to one side so the sensor does not read me. Thanks. |
