The_Widowmaker
Key Veteran
Location: Huntington Beach, CA
| I have three TT 600mm blades. Two are a close balance but will require some tape on one to balance. The balance point of each of these two blades does match. On the lighter of the two, some moron had drilled a 5.75mm hole about 60 mm from the tip of the root and poured bird shot into it and then plugged the hole with silicone. The bird shot was rolling around inside freely so I removed the plug and emptied the shot. When I flew these blades they did fine but noticed a flutter during right roll, which later I found the heli had a bent feathering shaft. I dont know if this was the cause of the flutter or not. The blades tracked fine in normal flight and on left roll / flip. Regardless there is no guarantee as to whether these blades do the same on your heli. They are not warped and will balance and thats all I can guarantee.
The third blades is just that, the third blade  Does not balance with either of the other two. It is heavier and would require entirely to much weight to balance. You could weigh it and try to find a matching blade or near matching blade for it.
3 blades... $60 pp/shipped to lower 48 verified address.
"I'm a Virgin.. I'm just not very good at it. " |
